Транзисторный цифро-аналоговый конвертор WLM Gamma Reference

Характеристики транзисторного цифро-аналогового конвертора WLM Gamma Reference
Digital Inputs:	(1) XLR connector, (1) RCA connector, (1) Toslink connector (optical), (2) Firewire connectors All inputs accept professional or consumer standard , i.e. accept AES/EBU or S/PDIF signals Sampling Frequencies: 44.1, 48.0, 88.2, 96.0, 176.4 or 192 kHz on any of the inputs Maximum input wordlength: 24 Bits Dual wire mode (internal jumper): channel 1 on XLR, channel 2 on RCA input, active at 176.4 or 192 only.
Digital Outputs:	(1) XLR connector, (1) RCA connector, (2) Firewire connectors Professional Channel Status Data on the XLR and RCA outputs Dual wire mode (internal jumper): channel 1 on XLR, channel 2 on RCA input, active at 176.4 or 192 only.
Analog Outputs:	(2) XLR Connectors (hot output on pin 2, servo controlled), (2) RCA Connectors DC coupled, short circuit proofed output circuitry, Output impedance: 50 Ohm Output level: Selectable by a rotary switch on the back, 4 settings, same level at both RCA and XLR outputs: +17 dBu (5.48Vrms) with a 0dBFS sinewave input +11 dBu (2.74Vrms) with a 0dBFS sinewave input +7.2 dBu (1.78Vrms) with a 0dBFS sinewave input +4.8 dBu (1.35Vrms) with a 0dBFS sinewave input
Synchronization:	Synchronized via input signal Extremely efficient Jitter attenuation down to subsonic frequencies Sampling Frequencies: 44.1 kHz, 48.0 kHz, 88.2 kHz, 96.0 kHz, 176.4 kHz, 192 kHz
Power:	Mains Voltage: 100...120 / 200...240 Volt Fuse rating: 500 mA slow blow at 100...120 V, 250 mA slow blow at 200...240 V Power consumption: 7 VA max. Power consumption in standby: 3 VA max.
Measurements:	The measurements below have been taken at the following conditions (unless noted otherwise): 1kHz measurement frequency, +17.0 dBu (equals 0dBr) output level at 0dBFS input, 48.0 kHz sampling frequency (fs), 22 kHz measurement bandwidth.
Frequency Response:	0 Hz ... 20 kHz: within ± 0.3 dB
Total Harmonic Distortion plus Noise (THD+N)	< −100 dBr (0.001 %) @ −3 dBFS input level
Linearity:	at 0 to −120dBFS input level:less than ±1dB deviation from ideal
Noise floor @ −20dBFS input:	< −107 dBr unweighted
Crosstalk:	< −110 dB, 0..20 kHz
Interchannel Phase Response:	< ± 0.5°, 10 Hz ... 20 kHz
Dimensions (W×D×H):	430×320×80 mm